Skip to main content
Start here: make sure your SugarPixel+ has the latest software installed. Install any update you’ve been notified about, and check your version under ≡ → General Settings → System.
SugarPixel+ shows Old Reading when no new reading has arrived for a while. If the account you entered has never had readings synced to it, SugarPixel+ shows Starting Up instead — see Display Stuck on “Starting Up”.
If the LibreLinkUp app also isn’t showing readings, or Libre is having a service outage, don’t change your SugarPixel+ settings. It recovers on its own — readings resume within 15 minutes after Libre data is back.
  • Entered your main Libre login instead of LibreLinkUp — these are separate accounts. SugarPixel+ uses the email address of the LibreLinkUp follower account, not the main Libre app login.
  • Same email on both accounts — if your Libre and LibreLinkUp accounts share an email, create a new LibreLinkUp follower account with a different address. Gmail users can use the + alias trick — e.g. myemail+sugarpixel@gmail.com delivers to the same inbox.
  • One LibreLinkUp account following more than one person — SugarPixel+ can switch between their readings. Use a separate LibreLinkUp account for each person.
  • Special characters in the password — avoid + , ’ ” in your LibreLinkUp password.
  • Third-party apps connected to LibreLinkUp — other apps connected to the same account can cause lockouts. Creating a dedicated LibreLinkUp account just for SugarPixel+ often resolves this.
  • Sensor started with the Libre reader — readings from a sensor started with the Libre reader aren’t shared to LibreLinkUp. Start the next sensor with the Libre phone app.
  • Libre connected to an insulin pump — if the sensor sends readings to a pump instead of the Libre app, they may not reach LibreLinkUp. If the LibreLinkUp app has no readings, SugarPixel+ can’t show them.
  • LibreLinkUp app has no readings — if your LibreLinkUp follower app isn’t showing current readings, SugarPixel+ won’t either. Resolve the upstream issue first; SugarPixel+ will update within 15 minutes once readings appear.
  • Recently changed phones, reinstalled the app, or switched CGM apps — you may have logged in with a different account or forgotten to re-add a follower connection. Redo steps 1–2 of LibreLinkUp setup carefully.
Tap Delete Connections in SugarPixel+, re-do steps 1–2 of LibreLinkUp setup carefully, then try again.